news

Contact us

  • Add:NO.2588 Longwu Road,
            Xuhui District, Shanghai
  • Tel:+86-21-34686835 
         Jackie:13916676968 
         Judy:15901623585            
  • Fax:+86-21-34686835
Home>>news>>Details on How to Repair Used Excavators

Details on How to Repair Used Excavators

Tags:2014-02-25

Used excavators get rid of big quantities of the oil for structure functions. Routine maintenance can determine and avoid most difficulties, like examining the oil filter or battery wires and cables. But occasionally unexpected repairs are required to get the device operating once again, like when the rubber monitor slips away the wheels or begins to tear. And how to repair used excavator? Find the monitor tension unit and entry plate on your used excavator. Every used excavator has a chassis method situated in a completely different spot centered on its kind and design.

Increase the used excavator from the oil at minimum 6 inches utilizing hydraulic jacks. Place the crane and bucket once towards the oil to maintain the device steady as you slide blocks below. Make sure the whole used excavator is stable on the blocks and jacks prior to creating repairs. Remove the tension include plate from the monitor frame if your used excavator has a single. Place the socket wrench once towards the grease and gradually get rid of. Insert the Allen wrench into the hole and push on the check ball within. Press a foot once towards the rubber monitor to loosen the anxiety and retract the anxiety/idler wheel.

Pull off the rubber monitor. Place the new track over the generate wheel sprocket with the steel hyperlinks fitting into the sprocket teeth. Slide the rubber monitor over the tension/idler wheel with the use of the pry bar. Push the bottom of the monitor with your foot right up until the steel hyperlinks straddle the wheel. Reinsert the grease into the monitor anxiety frame. Pump grease into the zirk with a grease gun. Quit applying grease when the monitor frame sags 3 inches.

Begin the used excavator and spot the motor on idle. Rotate the monitor in each instructions for many turns with the manage lever for the rubber monitor. Turn away the motor and verify the sag. Continue to rotate the monitor if the sag is far over 3 inches. Protected the tension include plate when the monitor sag continues to be at 3 inches. Consider out the blocks and reduced the hydraulic jacks right up until the used excavator is on the oil.