news

Contact us

  • Add:NO.2588 Longwu Road,
            Xuhui District, Shanghai
  • Tel:+86-21-34686835 
         Jackie:13916676968 
         Judy:15901623585            
  • Fax:+86-21-34686835
Home>>news>>How to Attach a Ground to Excavating Equipment

How to Attach a Ground to Excavating Equipment

Tags:2014-02-24

Functioning close to power lines or in stormy climate raises the threat of electrocution for all those working in or close to excavating gear. Just like a crane, a used excavator necessities to have a soil linked to the device to safely distribute electric expenses triggered by striking an power line or becoming struck by lightning. Even if there seems to be no immediate threat of becoming struck with an electric demand, it is fundamental to attach a soil to excavating gear, as an electric demand can bounce from an unsoiled item to the upcoming nearest and lead to electrocution.

Seek advice from the site power program to find underground utilities and the depth they are buried to pick an area for the soil rod that will not strike a unknown power. If a site program is unavailable, contact the nearby power firms and request each and every to mail someone to recognize the underground areas on the surface area of the soil. Mark feasible areas for the soil rod with orange recognizing paint. Ascertain that the areas do not interfere with underground utilities and are near sufficient to the used excavator for the soil guide to reach from the rod to the device.

Dig a post hole that is 8 ft deep for the soil rod making use of a hand-operated post hole digger or a pneumatic one attachment for the used excavator. Decline the soil rod into the post hole. The finish of the rod really should protrude from the soil 1 foot. Fill the hole with sufficient dirt so the rod can stand directly without the need of becoming used by hand. Turn on the multimeter and established it to study ohms. Touch the two probes to the soil rod at the very same time but in completely different areas on the pole. If the studying is much less than 25 ohms, move the rod to a new area and check once more. If the studying is 25 ohms or greater, get rid of the probes and turn away the multimeter. Fill the hole totally with dirt, ensuring that the soil rod continues to be directly.

Move used excavator into location. Clip a single end of the welding soil guide to the soil rod close to its bottom (exactly where it enters the soil). Extend the soil guide over to the used excavator. Choose a spot on the used excavator's steel entire body to attach the other end. Use the suggestion of the alligator clip on the welding soil guide to scrape the paint from the used excavator so bare steel is revealed. Attach the clip from the guide to the used excavator on the area that is displaying bare steel. Place an orange security cone on the rod protruding from the soil, producing certain not to dislodge the soil guide clip from the rod. This creates the rod area noticeable and allows stay clear of it becoming struck by device or automobiles. Tear one-foot-lengthy of yellow caution strips and knot them at 4-foot intervals on the soil guide among the rod and the used excavator to boost the guide's visibility.