news

Contact us

  • Add:NO.2588 Longwu Road,
            Xuhui District, Shanghai
  • Tel:+86-21-34686835 
         Jackie:13916676968 
         Judy:15901623585            
  • Fax:+86-21-34686835
Home>>news>>How to let a used Excavator working

How to let a used Excavator working

Tags: second hand mini excavators for sale used wheel excavator2014-02-17

The first thing , to check out between your legs, and then you will see there are two long steel rods ,and you should know that ,these things with a lot of handles attached on its top. You should know that these are the controls of drive and steer. Each controls the spin of the used excavator on the side of where it is located on, and pushing them forward causes the used excavator to move forward. Push an personal stick forward will cause the used Excavator to turn in the different direction, you will know that pulling a stick backward will turn the used Excavator in the way of where the stick pulled, and counter can rotate the tracks, you know it will cause the used Excavator to spin in one place.

When your push or pull these controls father, the used Excavator will move very fast, so when it is time to rotate with a crank and go, work these controls to slow and to smooth. You have to make sure that you are pay attention of what way the tracks are pointed before you travel. Make sure that the blade is on the front. Then to Push the levers away from you , then they will move the tracks forward ,you should to know about these but if you have twisted the cab ,and the result is, it will feel like that you are traveling backwards. This may effetely to cause a side out of your mind. If you try to go forward and the used Excavator moves back your inertia will make you, you have to know the resale, lean forward, then to push the controls harder. This just like the way the you must make a change of your way when you are driving a car in reverse, you will learn it with time.

Look down on the floor grounds, and you will see 2 more, the used control is not good. On the left, you will see either a small footboard or a thing worked with your left foot, this is you should to know, it is the high speed control, used to promote the drive pump and then speed the used Excavator 's travel when moving it from one place to another. In a straight path, this shape should only be used on smooth, level topography. On the right side is a footboard covered, it is with a hinged steel plate. When you open the cover, you will see a thing that is called the two way footboard. This footboard pivots the used Excavator's hoe left or right, so the used wheel excavators doesn't have to swing to reach the place, the place you need the bucket in. This should be used economical and only on stable, level ground because the load will not be reorganized with the equilibrant so the used Excavator, so it can tip over easier.